SURFACE PREPARATION

To ensure proper adhesion of the product, the painted surface must be cleaned of dust, grease, oil, peeled old paint, rust, mold or moisture residue.

- Mix component A and B with a low speed stirrer for 2-3 minutes. Leave the mixture and then repeat the stirring. The entire amount of A with B component must be stirred in the proportion given.

- If a smaller amount is to be applied then the ingredients need to be weighed in the same weight ratio, at a ratio of 3: 1 by volume with good agitation.

- Dilute the product with water at a rate of 5-10% for the desired workability

-Applied in one or two coats on dry, clean surfaces free of dust, loose and loose particles which prevent the product from sticking

- The product acquires all its mechanical strength after 20 - 30 days.

Caution: if we mix component A and B the product can not be stored and reused.

Avoid applying the product at temperatures below 6 ° C and above 40 ° C and when the relative humidity is greater than 80%. Adverse conditions during application may alter the final properties of the product.

CAUTION: Wear protective gloves / protective clothing / eye / face protection. In case of contact with eyes, rinse thoroughly with plenty of water for several minutes. If there are contact lenses, remove them if they are easy. Keep rinsing.

Immediately call the POISON CENTER or your doctor

7-9m² / kg per layer on properly prepared surfaces

5-10% water

1-2 hours according to weather conditions