SURFACE PREPARATION
- To ensure proper adhesion of the product, the surface to be painted must be cleaned of dust, grease, oil, peeled old paint, rust, mould or moisture residues.
- Mix component A and B in a ratio of 4:1 by volume with good stirring.
- Dilute the product with epoxy solvent at 5%.
- The product gains all its mechanical strength after 20 - 30 days.
Caution: if you mix component A and B, the product cannot be stored and reused.
APPLICATION CONDITIONS
Avoid applying the product at temperatures below 6°C and above 35°C and when the relative humidity is above 70% or if there is a possibility of rain or frost in the next 48 hours.
Adverse conditions and not following the application instructions may alter the final properties of the product.
APPLICATION TOOLS
- Brush
- Roller
- Spray gun
During working keep tools "liquid" in the container. Drain well the product of the tools back in the box and clean immediately with warm water and soap. If product dries, clean only with strong detergents. Do not empty washings into the groundwater.
WARNING: Wear protective gloves/protective clothing/personal protective equipment for eyes/face.In case of contact with eyes, rinse carefully with plenty of water for several minutes. If contact lenses are present, remove them if possible. Continue to rinse.
Call immediately the POISON CENTER 210 7793777.
10-12m2 /lt
1-5% with epoxy thinner
Full drying time: 7 days / 200C
Wetting time: 1 day / 200C
